#660569786
use of metrological precision tools for inspection (micrometers, rugosmeters, hardness tests, UT, 3D measuring devices/laser scanning)
Supervision of the gearbox load test procedure, monitoring temperatures, vibrations, cleanliness and oil pressure.
Perform the electrical tests of the cabinets mounted on the refurbished Nacelles, Hubs, as well as carry out the final operational tests of the unit.
Occasionally, it is necessary to work in narrow areas using ladders, platforms, scissor and arm lifts, more than 4 m above the ground.
Possess in-depth knowledge and the ability to use all the tools associated with assembling units according to the required specifications:
Read and understand mechanical design, engineering drawings.
Follow all EHS guidelines and policies.
Follow good environmental practices and waste management procedures. Separate the waste in the corresponding containers in the Repair Room.
Use and management of Quality documentation
Traceability
Calibration
Required Qualifications
School Diploma of Mechanics, Electricity and/or Electronics (FP2 in Spain)
Minimum of 2 years of experience working in a repair shop. Preferably from the Wind or Aeronautical Sector.
Knowledge of ALSPA MD 2000 Frequency Converter
Knowledge of ISO, AGMA and other standards applicable to the design, repair and failure modes of reducers and shafts.
Knowledge of ISO 9001, 14001 and 45001 Standards.
Be able to understand and read the lubrication analysis, according to ISO 4406.
Complete knowledge of bearing and gear mounting procedures and bearing clearance tolerances.
Be able to inspect using borescopic devices.
Knowledge of vibration and temperature measurement devices, being able to understand data and readings from vibration monitoring equipment and data trends.
Level B2 in English
Desired Characteristics
High ability to read, understand and follow mechanical, engineering drawings
It is also essential to have previous experience and certification in handling forklifts, personal lifts, and overhead cranes.
Self-motivated to work with a minimum of guidance and willingness to learn from others
END Level II certification training.
UT Level II Inspection Certification Training
CAT II Vibration Analysis Certification Training
Additional Information
Relocation Assistance Provided: No